Browsing this Thread:
1 Anonymous Users
|
Re: Change settings for GMA driver?
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
Then it might be a bit simpler problem if you're able to sometimes boot after Vesa and not a problem necessarily with EDID
Posted on: 2010/12/6 2:42
|
|||
|
||||
|
Re: Change settings for GMA driver?
|
||||
|---|---|---|---|---|
|
Home away from home
|
I had the same problem on my macmini ... however I was able to get it to work by saving a vesa screen-mode then restarting with the intel gma. It's a long shot but you could try it. =]
Posted on: 2010/12/6 2:29
|
|||
|
||||
|
Re: Change settings for GMA driver?
|
||||
|---|---|---|---|---|
|
Home away from home
|
There are some problems with the GMA driver parsing EDID information from some display devices. There is no commandline parameter that you could pass in from grub I'm afraid.
Posted on: 2010/12/5 17:32
|
|||
|
||||
|
Change settings for GMA driver?
|
||||
|---|---|---|---|---|
|
Quite a regular
 
|
When I try launching Icaros 1.2.5 on my iMica, the GMA driver defaults to a resolution that my monitor doesn't support. I can launch successfully in the lower resolution VESA mode.
Where do I find the settings to adjust my GMA resolution while in VESA mode?
Posted on: 2010/12/5 15:17
|
|||
|
||||
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
You cannot use topic type.
You cannot use HTML syntax.
You cannot use signature.
You cannot create PDF files.
You cannot get print page.
